Home | Receivers | Satellite | Digital Free-To-Air | PrimaSat II

Demodulator
Modulation: QPSK
Input Symbol Rate: 2~45 Ms/s
SCPC & MCPC signals from C & KU band satellites

Video Decoder
Profile level: MPEG-2 MP@ML
Input Rate: Max. 60 Mbits/s
Video Resolution: 720 x 576 pixels (PAL), 720 x 480 pixels (NTSC)
Aspect Ratio: 4:3, 16:9

Audio Decoder
ISO/IEC 11172 LAYER I&II
Sampling rate: 32, 44.1, 48 kHz
Audio modes: Stereo, Dual mono, Mono

Tuner
Front-End: DVB-S
Input Frequency Range: 950 ~ 2150 MHz
RF Input Level: -25 ~ -65 dBm
LNB Power: 13/18 V DC (+/- 5%)
Max. 500 mA, Overload protected
DiSEqC Version: 1.0, 1.1 & 1.2

System and Memory
Flash Memory: 16 Mbits
SDRAM: 64 Mbits

Connectors
SAT IN
SCART TV (RGB, CVBS)
S/PDIF: coaxial output
USB port

General Data
Input Voltage Range: 100 – 240 V AC 50/60 Hz
Power consumption: max 18 W, typ. 4.6 W
Stand-by Power consumption: 0.5 W (max.)
Operating Temperature: +0°C ~ 40 ° C
Storage Temperature: -30°C ~ 80°C
Operating Humidity Range: 10% - 85%, RH, Non-condensing
Size (WxDxH): 180 x 130 x 45 mm
Weight: 0.45 kg

• English
• Deutsch
• Italiano
• Pусский

• English
• Deutsch
• Française
• Italiano
• Pусский

The display on front panel does not light up.

The power cord is not plugged in.
Receiver is in stand-by mode.
Your model is without display.

Check, that the power cord is plugged into the wall outlet.
Switch ON receiver.
Your model is without display.

No picture or sound

Wrong connection of the Audio/Video output of the receiver to TV.

Connect the Audio/video output of the receiver to TV correctly.

Audio muting.

Wrong Audio channel

Press the Mute button.
Press AUDIO button and select other audio channel

TV power off, wrong channel or input.

Turn on TV, select correct channel or input.

No picture

The receiver can’t receive the signal

Check the antenna cable, replace the cable, or connect the cable to the receiver tightly.

Incorrect values of some tuner parameters.

Set the values of the tuner parameters correctly in the installation menu.

Wrong direction of the dish

Check the signal strength with a spectrum analyzer and adjust your dish correctly.

The remote control does not work

The batteries of the remote control are not inserted or exhausted

Check whether the batteries are inserted correctly in your remote control. Check the batteries, and if exhausted replace the batteries in the remote control.

The USB storage device is not recognized.

Wrong formatted

Make sure that your USB device use file system FAT32.

The external USB HDD does not start.

Power consumption is too high.

Connect extra power supply adaptor to your USB HDD.

The receiver switches off automatically.

Auto Standby function enabled.

Disable Auto Standby. See section 4.1.4 for details.