Demodulator:
Demodulator: COFDM ; 16 QAM/64 QAM
Transmission mode: 2 K - 8 K

Audio Decoder:
MPEG MusiCam Layer II
Sampling rate: 32, 44.1, 48 KHz
Audio mode: Stereo, Mono

Memory and System:
Flash memory: 4 MByte
SDRAM: 32 MBytes

Video Decoder:
Profile level: MPEG-2 MP@ML
Video resolution: 720 x 576 pixels (PAL), 720 x 480 pixels (NTSC)
Decoding & Video Out: PAL
Aspect ratio: 4:3, 16:9

Tuner:
Front End: DVB-T, UHF & VHF Tuner
Input frequency range: 174 – 230 MHz (VHF) and 470 - 864 MHz (UHF)
Loop through frequency range: 47 - 864 MHz
Input signal level: -82 ~-20 dBm

Connectors:
ANT IN - IEC Female
TO TV - IEC Male
TV SCART (RGB, CVBS)
VCR SCART (Composite Video, Audio L/R)
2 RCA (Audio L & R)
S/PDIF: optical output

General Data:
Supply Voltage :100 - 240 V AC (SMPS), 50/60 Hz to 12 V DC
Power Consumption: typ. 5 W, max. 10 W
Power consumption in stand-by: < 3 W
Operating Temperature: 0°~ 40°C
Storage Temperature: -30°~ 80°C
Operating Humidity Range: 10~85%, RH, non-condensing
Size (WxDxH) in mm: 260 x 157 x 34

• English
• Française
• Español

• English
• Française
• Español

No signal found

Antenna is disconnected

Antenna is damaged/misaligned

Out of digital signal area

Active antenna requires to switch ON antenna power/external feed

Check Antenna lead

Check Antenna. Check with dealer

Switch receiver’s  Antenna Power ON/ connect external feed

No picture or sound

Scart/AV* is not selected on your TV

TV or VCR are not connected to main

Switch to correct TV input

Check mains lead

Sound but no picture

Antenna poorly adjusted or defective

Program is being broadcasted with altered parameters

SCART connector not fully plugged in

Check Antenna

Do an automatic search (see chapter 7)

Check SCART connector

Poor image quality or no colours

Wrong TV SCART out signal

Inappropriate video type selected

Try changing from RGB to CVBS or vice versa

Set video output according to TV set video requirements

Cannot receive a channel that you could receive before

Channel is no longer broadcasted

Interference with „DECT" phones or wireless equipment

Channel is being broadcasted with altered parameters

None

Move phone/wireless equipment away from the receiver to a location where interference ceases

Do an automatic channel scan.

Certain channels cannot be received from time to time

These services are not transmitted 24 hours a day and are sometimes not available. This is not a fault.

No response to remote control unit (RCU)

Receiver off

RCU not aimed correctly

Front panel obstructed

RCU batteries exhausted

Plug in and turn on

Aim RCU at front panel

Check for obstructions

Replace RCU batteries

Forgotten or lost PIN code

Contact local Service Hotline or send email to our Support via www.strong.tv

After moving the receiver to another room you are no longer able to receive digital reception

The Antenna feed former new point may come through a distribution system which may reduce the digital signal now received by the receiver.

Try a direct feed from the antenna