Software


SRT 8211 - SW v 2.3.8 - 11/14/2018

Contents

Dear customer! 

Here you can download the new software for your receiver. Please uncompress the downloaded zip file and read the instructions carefully before you load the firmware into your receiver! The zip file consists of: 

1) Firmware: sky_usb.cfg ; SRT8211_V238_20181018.bin

2) Release notes

3)  Update Instruction:

a) At the PC: 

Extract the .bin and .cfg file from the package to the root directory of the connected USB device. Please make sure the connected USB device procides sufficient free storage capacity (~50 MB)! Then disconnect the USB device from the PC and connect it to the receiver. 

b) At the Receiver: 
Switch ON your receiver and connect the USB device with the software to the connector at the corresponding port of your receiver. After the USB device has been inserted, you can perform the software update according to the following steps:

1. Wait until the receiver successfully detects the connected USB device – a massage will inform you.

2. After this wait for short until the receiver informs you that there is new SW detected on your USB.

3. Now use the ◄► buttons to select OK and press OK to perform the update.

4. Your receiver will reboot into Update mode, please wait patiently until the update process is finished! Once the update procedure is finished, the display will show “End” and “Good”.

5. You can remove the USB device from the receiver now please!

If you're going to use the same USB device with the receiver, please remove the update files from it!

Release notes

SW Version 2.3.8 from 18.10.2018

The following improvements were realised:

•  Instant recording time can be edited now

Attention

NEVER disconnect the USB device from the receiver, the receiver from the main or switch OFF power during the update procedure. It can damage your receiver and warranty will void! As soon as the update has been finished, the receiver restarts automatically within the „First time installation“!
With the download of this software you confirm, that any risk of usage shall not be passed to STRONG!
SW v 2.3.8